Pentair Intellitouch ScreenLogic, Руководство пользователя

Страница: 48 / 116

38
IntelliTouch ScreenLogic User’s Guide
Assign a Circuit Name and Function
Note: Before you assign circuit names in ScreenLogic, write down the circuit names and assigned buttons
on the Outdoor Control Panel (in the Load Center). The circuit names you assign in ScreenLogic should
match the button labels on the Outdoor Control Panel.
Circuit Functions let you assign special logic to the circuits. For example, when setting up an automatic pool cleaner
pump, you would assign the circuit function MASTER CLEANER. With this “Cleaner” logic the cleaner pump
would not run without the filter pump being on first, and, the cleaner pump would automatically shut off whenever
the spa is switched on. The cleaner will go on after the five minute delay. Also, the automatic cleaner pump will turn
off when the spa and/or solar is turned on. Be careful not to duplicate circuit names with these circuits. These
circuits may also be used to activate two-speed pumps to high speed, turn additional valves, etc.
To assign a circuit name:
1. Start the ScreenLogic Configurator and click Configure IntelliTouch .
2. Click Next on the General Setting page. The Setup Circuits (Step 2 of 5) page is displayed.
3. From the Circuit Name drop box, scroll through the alphabetical list of predefined circuit names and select a
circuit name. For a complete list of the IntelliTouch Circuit Functions, see page 39.
Note: You can also customize circuit names. To enter a custom circuit name, click Set Custom Names ,
and select one of the user names (USER NAME 01-20) and type in the new circuit name (11 characters
maximum). The Custom Names (USER NAME 01-20) can be found at the bottom of the circuit name
drop down box. If you are using the Tablet, use the virtual keyboard to enter the new name. For more
information about the virtual keyboard button, see page 11.
4. From the Circuit Function drop-down box select the function assigned to the circuit name. For a complete
list of the IntelliTouch circuit functions, see page 39.
Note: If the assigned function requires freeze protection, select the check box for “On with Freeze.”
Note: When you are finished setting the first circuit name and circuit function, repeat Steps 3 and 4 and
assign the other circuits and functions. Depending on the IntelliTouch model you are programming,
equipment may not be installed for all available circuits shown.
5. Display Circuit Button on ScreenLogic main screen: For easy access, the assigned circuit button can be
displayed under Pool, Spa, or Water Functions on the ScreenLogic Main screen. To display the button on the
Main screen, select where you want the button to display in the
Show with drop-down box.
Note: IntelliBrite, SAm, SAL lights, and Color Wheel buttons will always display on the Lights screen.
6. Click Finish to save the current settings.