Pentair INTELLIFLO 100, Инструкция по установке и эксплуатации

Страница: 12 / 36

6
IntelliFlo 4 Installation and User’s Guide
Starting the pump
To start the pump
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button (LED on) to start the pump.
Note: When the pump is using a modified speed and is powered down, the next time the pump is
powered up, the pump will use that same speed.
Stopping the pump
To stop the pump
• Press the Stop button to stop the pump.
Note: The pump can automatically restart if the communication cable is connected.
Resetting the pump to factory defaults
The IntelliFlo 4 pump can be reset to the factory default settings. All previously adjusted pump speeds that were
saved will be erased.
To reset the pump to the factory default settings:
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Stop button to stop the pump.
3. Press and hold all of the four Speed buttons simultaneously for three seconds. Power off the drive
and reenergize. The default settings will be in effect.
Assigning a pump address for remote control
The default communications address for the IntelliFlo 4 is 1. This is the only IntelliFlo address that the
EasyTouch and IntelliComm systems will communicate with. Therefore these devices can only communicate
with one IntelliFlo 4. The IntelliTouch is able to communicate with four Intelliflo 4 pumps. If more than one
IntelliFlo 4 is being used with an IntelliTouch the 2nd, 3rd and 4th pumps will have to be readdressed as
described below.
To assign a pump an address:
1. Be sure that the pump is powered on and the green power LED is on.
2. Press the
Stop buttons to stop the pump.
3. Press and hold both the Start and Stop buttons until the red LED will starts flashing, then press one
of the four speed buttons to select which address to assign the pump.
4. Press and hold both the Start and Stop buttons to save the address. Repeat the process for the
other pumps.
Control Panel Speed Buttons