Pentair IntelliCenter 522039Z, Руководство по установке

Страница: 2 / 12

2
IntelliCenter Control System Expansion Card and Pool Cover Installation Guide
IntelliCenter Control System Expansion Card and Pool Cover Installation Guide
Access the Outdoor Control Panel in the Load Center or Power Center
The IntelliCenter ® Control System Main Motherboard Outdoor Control Panel is located in the top part of
the Load Center or Power Center enclosure. See Figure 2.
To access the Main Control Panel Motherboard:
1. Unlatch the front door spring latch and open the front door of the Load Center enclosure.
2. Loosen the two (2) retaining screws securing the high voltage cover-panel. Remove the HIGH
VOLTAGE COVER PANEL from the enclosure (as shown below).
BEFORE INSTALLING AN INTELLICENTER™ CONTROL SYSTEM EXPANSION OR
PERSONALITY CARD ALWAYS SWITCH OFF AC POWER TO THE LOAD AND/OR
POWER CENTER AT THE MAIN HOUSE CIRCUIT BREAKERS.
Figure 2: IntelliCenter Load Center Control System Load Center (front view)
(High Voltage Cover Panel removed)
High Voltage Cover Panel Tabs (3)
Remove two (2) retaining screws
securing High Voltage Cover Panel
Front door
High Voltage Cover Panel slots (3)
Flip down the Outdoor Control Panel to
access the Main Motherboard circuit board
Loosen Outdoor Control Panel
retaining screws
3.
Install the Pool Cover Expansion Card onto the Main Motherboard (See Figure 3, page 3):
4. Carefully align the Pool Cover card edge connector (component side facing up) with the card edge
pins on the Main Motherboard (if using Slot 1) or other card. Slide the Pool Cover Expansion card
onto the card edge connector.
5. Secure the Pool Cover Expansion card in place with the two retaining screws (provided in kit).