FILTRATION & PROCESSING SOLUTIONS
QL1
-
, QL2
-
, QL3
-
, QL3B
-
BH
2
WATER FILTER IO GUIDE
The Everpure BH
2
Water Filters reduce chlorine tastes and odors and other substances that produce off-tastes and odors in
coffee. The BH
2
also reduces dirt and rust, and reduces the formation of limescale* which builds up on the brewer heating
elements and in the reservoir.
INSTALLATION
The following instructions provide for installation of a
QL1
-
, QL2
-
, QL3
-
, QL3B
-
BH
2
Filter regardless of whether or not the
brewer is already installed. The label on the BH
2
Cartridge illustrates and explains the procedure for cartridge insertion and
removal into the filter head. The filter cartridge should be placed into the head after the system has been installed.
1. Install the filter as close to the brewer as possible. Do not connect this filter to any other equipment. Connect only to the
cold water line and do not expose it to high temperatures.
2. Select a location for the filter, nominally 4 x 4 x 18 inches (10 x 10 x 45.7 cm) long, including a 2.5-inch (6.3 cm) drop-down
for cartridge changes. Write the installation date and anticipated cartridge replacement date in the space provided on the
cartridge label. The cartridge should be replaced every 12 months or after 6,000 pots (3,000 gallons, 11,356 L) have been
brewed, whichever occurs first.
3. If required, shut off the incoming water supply and relieve pressure in the tubing. Cut the tubing, allowing a 4-inch (10 cm)
space for the filter installation between the water supply and the brewer water inlet.
4. Install appropriate fittings into each port of the head. Use a good grade of pipe dope or plumber tape on the body threads.
Do not overtighten the fittings.
5. Position the head assembly so that the arrow shown on top of the head corresponds to the direction of water flow and
attach the incoming cold water supply to the inlet of the head.
6. Connect the filter outlet to the brewer water inlet line. Use compression or flare fittings to make water connections to
the brewer.
7. Mount the head to the wall using the screws and star washers provided.
8. Install the cartridge into the head following the instructions on the cartridge label.
9. Turn on the water and check for leaks.
NOTE: The cartridge must be flushed before use by running water through it at maximum flow for three minutes to purge
the cartridge of air.
Rated Service Flow:
0.5 gpm (1.9 Lpm)
Temperature:
35-100°F, (2-38°C).
Min./Max. Line Pressure: 10-125 psi (0.7-8.6 bar), non-shock.
Capacity of a Single Unit: 3,000 gallons (11,360 liters).
For cold water use only.
This water filtration system must be maintained in accordance with the manufacturer’s instructions, including the timely
replacement of filter cartridges.
This product is intended for commercial use only. Home or similar consumer use VOIDS THE WARRANTY.
Check for compliance with state and local laws and regulations. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
The term ‘bacteriostatic’ indicates that the system limits the passage or growth of bacteria that may already exist in the
incoming water. It does not mean that the water leaving the system is safer to drink than the water entering the system.
EVERPURE
®
QL1
-
, QL2
-
, QL3
-
, QL3B
-
BH
2
WATER FILTERS
