Pentair AQUATRAM 90, Инструкция по установке и эксплуатации

Страница: 11 / 24

24-VOLT BATTERY SYSTEM OPERATING AND
INSTALLATION INSTRUCTIONS
The AquaTRAM
®
90 Swimming Pool Access Lift comes with a 24v sealed rechargeable
battery, wall mount charging unit (with mounting bracket), control box, and a waterproof
handset controller. The control box is mounted to the AquaTRAM 90 Pool Lift
and has a
plug-in socket for both the actuator and the handheld controller. The battery mounts
directly above the control box with a quick-release clip.
To operate the AquaTRAM 90 Pool Lift, plug in the handset controller to the control box
and push the corresponding button to either lower or raise the unit. The lift should be
able to complete approximately 10-20 full cycles before the low battery indicator tone will
sound. The low battery tone indicates that there is approximately 20% battery life
remaining. At this point, DO NOT ATTEMPT TO OPERATE THE LIFT, remove the
battery from the unit and recharge on the wall mounted charging unit.
To recharge the battery, simply grip the top of the battery and depress the clip on the
back of the battery. This will unclip the battery from the control box bracket and the
battery can then be clipped into the wall mount charger. When the
charger is plugged in
the green ON light will illuminate. When the battery is correctly mounted to the charger,
the orange CHARGE light will illuminate. When the battery is fully charged, the
CHARGE light will GO OFF and the battery is ready for use.
WHEN THE BATTERY IS NOT BEING USED IT SHOULD BE STORED ON THE
CHARGER AND NEVER ON THE LIFT.
10