QuickTouch
®
II Wireless Remote Installation and User’s Guide
17
To assign spa-side remote buttons (1-4) and (5-8):
Press the
Up/Down buttons
and select the “Top” or Bottom” row to assign circuits. Press
the
Right button
to select a circuit to one of the remote buttons. Five top row buttons can
be assigned circuits (1/5, 2/5, 3/5, 4/5 and 5/5). Press the
Right button
to move to the
circuit setting. Press the
Up/Down buttons
to configure the first button on the remote,
scroll through the circuit names and find the circuit that you would like to assign to the
first button on the remote. The default circuit selections are:
None, Spa, Pool, Aux 1-7
(EasyTouch 8), Feature 1-8, Solar (if selected in “Heat” menu), Heat Boost, Heat
Enable, Pump Incrs, Pump Decrs
. “Aux Extra” is displayed only available if the Solar
output (J17) plug on the EasyTouch circuit board is not being used for solar equipment.
Use the Solar button to switch the extra circuit on and off. Selecting “None” does not
assign a circuit.
Note:
The “Heat Boost” feature will switch on the heater for seven
minutes to increase the spa water temperature. Each time the spa Heat Boost button is
pressed, the temperature will increase about 1° F. The temperature will not go beyond the
104° F limit. Press the
Right button
to assign the next circuit (2/5). When finished, press
the
Menu button
to save the settings and to return to the Settings menu options. Press
the button twice to return to the main screen.
Setting up QuickTouch II Wireless Remote (EasyTouch)
From the EasyTouch control panel menu, you can specify any SpaCommand spa-side
remote button to control different functions by assigning each button to a specific circuit.
The spa-side remote has 10 assignable circuit buttons; five button on the top row and five
buttons on the bottom row. The following setup instructions are described in the
EasyTouch User’s Guide (P/N 520584).
MENU
▼
SETTINGS
▼
IS10 ASSIGN IS10
Getting There
▲
MENU
▼
SETTINGS
▼
iSx PUMP CNTRL ASSIGN IS10 & 4QT4
Getting There
▲
EasyTouch Settings Menu: iSx Pump Cntrl and SpaCommand Control
From this menu setting you can specify the IntelliFlo VS or VF pump speed (RPM, GPM)
in step increments using the “Pump Incrs” or “Pump Decrs” circuit. The SpaCommand
remote
Up/Down buttons
are assigned to the “Pump Incrs” and “Pump Decrs” circuits.
Each press of the Up/Down button will increase and decrease pump speed or flow rate
in specific speed increments, as specified in the “iSx Pump Cntrl” EasyTouch menu
setting. Speed increments are set from 10 to 250 RPM or 1 to 10 GPM.
EasyTouch menu: To assign a pump step speed or flow rate:
Press the
Up/Down button
to select the “Pump Number” as
specified in the IntelliFlo menu. Press the
Right buttons
and
select the pump “Step” speed. Press the
Up/Down buttons
to
adjust the “Step” pump speed. Settings are: IntelliFlo VS, 10 to
250 RPM, IntelliFlo VF 1 to 10 GPM.
Press the
Menu button
to save the settings and to return to the
Settings menu options. Press the button twice to return to the
main screen.
Assign iS10 & 4
Pump Controls
Pump Number: 1
Step GPM: 001
Assign iS10 & 4
Pump Controls
Pump Number: 1
Step RPM: 010
