QuickTouch
®
II Wireless Remote Installation and User’s Guide
10
INTELLIBRITE 5g POOL LED LIGHT FIXTURE INSTALLATION
(NEW POOL CONSTRUCTION)
The QuickTouich II transceiver is connected to the EasyTouch, IntelliTouch and
SunTouch system via an RS-485 four wire communication cable.
To connect the transceiver cable to EasyTouch, IntelliTouch and SunTouch load center:
1.
2.
Unlatch the load center front door spring latches, and open the front door.
3.
Remove the two screws securing the
high voltage cover-panel
, and remove
it from the enclosure (illustration below shows cover-panel removed).
4.
Loosen the two control panel access screws and fold down the outdoor
control panel.
WIRING THE QUICKTOUCH II TRANSCEIVER TO THE LOAD CENTER
All electrical installation,
including electrical wiring
methods and materials used to complete the electrical
installation of the EasyTouch and IntelliTouch Pool/Spa control system
MUST BE PERFORMED BY A SERVICE PROFESSIONAL AND/OR
UNDER DIRECT SUPERVISION OF A QUALIFIED ELECTRICIAN
in
accordance with the National Electrical Code or the Canadian Electric
Code, as well as any local electrical codes in effect at the time of
installation.
Refer to NEC 680-21 (b) or CEC 687-060, 062, and 066 for
further details.
Retaining screw
Run wire up low
voltage raceway
to main circuit
board
Control panel
(fold down to
access COM
port on circuit
board)
Retaining
screw
Retaining screws
(High voltage
cover-pane
shown removed)
Switch OFF the power to the load center at the main
circuit breaker before removing
the High Voltage
Cover Panel. Failure to do so could result in personal
injury and/or death. Shorting wires may permanently
damage unit. Close all panels and load center front door
when remote installation is complete.
