Pentair Pool Products IntelliFlo VF, Инструкция по установке и эксплуатации

Страница: 50 / 103

48
IntelliFlo VF Installation and User’s Guide
Pump Strainer Basket Service
(Continued)
10. Ensure that the lid o-ring is properly placed. Seat the clamp and lid then turn clockwise until the handles
are horizontal as shown.
11. Reconnect the communication cable to the pump if required.
12. Switch the power ON at the circuit breaker. Reset the pool time clock to the correct time.
WARNING - FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART
OF THE CIRCULATING SYSTEM (e.g., LOCK RING, PUMP, FILTER,
VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND
BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID
TO BLOW OFF WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR
PROPERTY DAMAGE. TO AVOID THIS POTENTIAL HAZARD, FOLLOW
THESE INSTRUCTIONS.
13. Open the manual air relief valve on top of the fi lter.
14. Stand clear of the fi lter. Press the Start button on the pump.
15. Bleed air from the fi lter until a steady stream of water comes out.
16. Close the manual air relief valve.
Motor Service
1. Protect from heat:
Shade the motor and controller from the sun. •
Any enclosure must be well ventilated to prevent overheating. Particular attention should be paid to •
the motor fan cover and the cooling fi ns between the drive and the motor.
Provide ample cross ventilation.
•
2.
Protect against dirt:
Protect from any foreign matter or splashing water. •
Do not store (or spill) pool chemicals near the motor. •
Avoid sweeping or stirring up dust near the motor while it is operating. •
If a motor has been damaged by dirt it voids the motor warranty. •
3. Protect against moisture:
Protect from splashing pool water. •
Protect from the weather. •
Protect from lawn sprinklers. •
If a motor has become wet - let it dry before operating. Do not allow the pump to operate if it has been •
fl ooded.
If a motor has been damaged by water it voids the motor warranty.
•
Note: DO NOT wrap motor and controller with plastic or other air tight materials. The motor and
controller may be covered, but not wrapped in plastic, during a storm, for winter storage, etc., but never
when operating, or expecting operation.
When replacing the motor, be certain that the motor support is correctly positioned to support the size of
motor being installed.
Clamp
Lid
Volute