28
IntelliChlor Electronic Chlorine Generator Installation and User’s Guide
Connecting the IC20, IC40 or IC60 Power Center to an
IntelliTouch, EasyTouch or SunTouch System
To operate IntelliChlor with the IntelliTouch, EasyTouch or SunTouch system, connect a four wire cable from
the IntelliChlor Power Center to the IntelliTouch, EasyTouch or SunTouch load center. An alternate connection
can be made by splicing anywhere along the four wire connection that connects the IntelliTouch or EasyTouch
indoor control panel to the load center.
Note:
See the following manuals for IntelliChlor operating instructions:
- IntelliTouch User’s Guide (P/N 520102)
- EasyTouch User’s Guide” (P/N 520584)
- SunTouch User’s Guide” (P/N 520785)
CAUTION - Wire the Power Center AC to the filter pump relay on the LOAD SIDE for maximum safety.
To connect IntelliChlor Power Center four wire cable to the IntelliTouch, EasyTouch or SunTouch load center:
1. Remove the cover screw securing the Power Center cover. Remove the cover.
2. Run a UL approved four conductor cable (22 AWG) from the IntelliChlor Power Center to the Load
Center. The preferred wire color scheme is red, yellow, green, and black.
3. Remove the cover screw securing the Power Center cover. Remove the cover.
4. Remove one (1) of the knockouts from the underside of the Power Center.
5. Route the four conductor cable up through the lower hole.
6. Strip back the cable conductors ¼ in. Insert the wires into the screw terminals (provided in the kit).
Secure the wires with the screws. Make sure to match the color coding of the wires; Red = +15,
Yellow = +DT, Green = -DT, and GND = Black.
7. Plug the screw terminal onto the four (4) pins located on the Power Center board.
8. Reinstall the cover and secure with the cover screw.
9. Proceed to “Connecting IntelliChlor to an IntelliTouch System,” on page 29, “Connecting IntelliChlor
to an EasyTouch System,” on page 30, and “Connecting IntelliChlor to a SunTouch System,” on
page 31.
Conduit knockout
Screw terminal
IntelliChlor Power Center
(cover removed)
Screw terminal
pin-outs
1
D
N
G
K
L
B
2
T
D
-
N
R
G
3
T
D
+
L
E
Y
4
V
5
1
D
E
R
WARNING
- Switch OFF main system power to the Load Center before making any connections.
Содержание IntelliChlor IC60
