- 10 -
1.
Start the air blower by pressing the Aqua-Aire ON/OFF button.
2. Apply desired amount of bath oil and shampoo.
WARNING
In the following bathing instructions the resident is required
to rinse themselves with the shower sprayer. Before doing so
each time, make sure the temperature is between 95 and 105
degrees Fahrenheit by viewing the temperature readout. As a
further precaution, always test the water on the inside of your
wrist before turning on the shower sprayer. Failure to follow
the precautions in this warning could result in a burn injury to
the resident.
3. The resident Bathes the upper body as follows:
a) Apply bathing oil or shampoo to the body.
b) Begin gently washing the upper body. Pay special
attention to folds or creases in the skin and under the
arms. If the scalp is flaky, apply a small amount of bath
oil to the problem area and let it soak in until time for
shampoo.
4. Rinse the upper body with the shower sprayer as follows.
a) Pick up the Hand-Held Shower Sprayer located on the
side of the tub rail as shown in (figure 1)
b) Press the Shower Button to activate the Shower
Sprayer.
c) While pointing the sprayer into the tub,
not onto the
body
, press the Shower Trigger, located on the sprayer.
d) Adjust the water temperature by turning the Temperature
Control Knob to the normal bathing range of 95 to 105
degrees Fahrenheit as shown below. Monitor the
temperature by viewing the Fill/Shower Temperature
