Exiting the Spa
Exiting-Cleaning Spa
760750 Rev A
Exiting the Spa
After the bath is complete, you are now ready to exit the spa.
1. Leave the air blower on to allow warmer water to circulate around the resident while the bath is draining.
2. Drain the spa
bye pulling the drain plug from the drain. Allow the spa to be completely drained.
3. Unlock the door by pulling the door handle back or towards the residents.
4. Open the door to the widest position.
5. Dry Off.
6. Swing legs around and place feet on the floor.
7. Use proper nursing techniques to transfer to a wheelchair or other chair to finish hair, nail, shaving, etc.
8. After finishing your bath routine, leave the bathing room.
9. The Dream Spa is now ready to disinfect.
Failure to having the spa completely drained before unlocking the
door could cause injury. Be aware of possible water on the floor
when exiting spa. Take necessary precautions to avoid slipping
and/or falling such as: proper support, secure grips to hold,
physical assistance, non-slip bath matts.
WARNING
System Cleaning (after bath)
Clean and disinfect the spa after every bath with Penner Cleaner/Disinfectant as follows:
NOTE:
PENNER CLEANER/DISINFECTANT IS A SPECIAL NON-ABRASIVE CLEANING AND DISINFECTING
SOLUTION THAT WILL NOT HARM THE SPA’S FIBERGLASS SURFACE. PENNER CLEANER/DISINFECTANT IS
THE ONLY CLEANING SOLUTION DESIGNED AND RECOMMENDED FOR USE WITH YOUR DREAM SPA
.
Some cleaners, disinfectants, and floor strippers contain ingredients that are corrosive or
abrasive. These solutions or compounds may contain chlorine, acid, basic ingredients or
abrasives. DO NOT allow such solutions or compounds to come in contact with your Penner
equipment. Failure to heed this caution could result in damage to the equipment and void the
warranty.
Cleaning of this equipment by untrained personnel could result in injury to the operator or
patient.
CAUTION
1. Close and lock the door.
2. Push Aqua-Aire button to start the blower. Let run for 5 seconds. Push Aqua-Aire button again until blower turns
off.
3. Remove any visible tissue, residue, or fluids from the spa by using the shower sprayer and rinsing the inside spa
surfaces.
4. Place plug into the drain.
5. Using a 16oz squirt/spray bottle, pour ¼ oz to 1oz of Penner Disinfectant into the bottle and then add 16oz
water. Squirt/spray the disinfectant solution throughout the spa. Making sure to use a liberal amount of
disinfectant solution.
8
1-800-732-0717
www.pennerbathing.com
1-866-736-6377