Pendix Eco ePower300, Инструкции системы

Страница: 12 / 16

12
System part Measure taken
Battery Make sure that the contacts at the bottom of the battery are free from impurities/dirt etc.
Make sure that the contacts at the bottom of the battery do not touch metal parts of any kind.
When plugging the battery into the bicycle, make sure that the LED display indicates successful contact with the motor: it should light up in the color of the charging status
selected.
Check to see how hot the battery unit is. If necessary, allow it to cool down before checking again whether functioning is in order.
Can the defect be corrected by charging the battery? Check accordingly.
Check to see whether the defect can be corrected by pushing the ON/OFF button down for 40 seconds. In this way, the battery software is restarted.
Charging unit Make sure that the charging unit is plugged into the wall socket.
Make sure that the battery is properly connected to the charging unit. You can see this when the LED display lights up in the color of the charging status selected (connection
is then OK).
Make sure that you are using the proper charging unit only.
Drive system
(unit)
Make sure that the spoke-mounted magnet for the wheel speed sensor is correctly mounted and pointing towards the sensor surface opposite.
Make sure that the wheel speed sensor is tightly attached to the chain bar.
Make sure that the plugs on the rear of the motor are tightly in place.
Make sure that the contacts of the plug on the battery holder are free of impurities or obstructions.
Make sure that the contacts of the plug on the battery holder do not touch any other metal parts or surfaces.
Make sure that there are no visible signs of damage along the cable connection between the motor and the battery, and that all wires are properly laid out and accessible.
Check to see if the motor is warm. If necessary, allow it to cool down before checking to see whether it is now functioning.
Using a suitable attachment to your car (bike rack), you can
always transport your Pedelec in the same way as a bicycle.
• Note: as the Pedelec weighs more than a normal bicycle,
your bike rack must meet the proper requirements.
8. Transporting your
Pedelec
8.1 By car
8.2 Using public transport
Take the battery off prior to transport, and always
store it seperately during transport.
Here, the same rules apply as when transporting a bicycle.
8.3 By airplane
In this case, the battery must be declared for transport as
dangerous freight. The battery must be labeled as such. Ask
your air transport company for advice.
9. Disposal
Motor unit, battery, electronic bottom bracket, wheel
speed sensor, component parts and packaging should al-
ways be recycled or disposed in a way compatible with the
environment.
Do not dispose of your Pendix motor or Pendix
components in domestic waste containers!
In accordance with European Directive
2002/96/EU, usable electrical equipment
must no longer be disposed through normal
channels, and in accordance with the European
Directive 2006/66/EU, defective or
used batteries must be collected separately
and be disposed in an environmentally safe
recycling system. Always return batteries
that are no longer usable to your authorized
bicycle salesman/ technician.
For safety reasons, remove the battery from your Pedelec
when boarding a bus or train, and replace it when the jour-
ney is over.