#950130-001 -
Product Manual: Model #6759 WORK UMBRELLA
- Revision 00 - Date: 09-06-2016
Page 12
5.0 - Product Operation
5.1 - Product Description & Capabilities
The following section will address the capabilities and the general operation of the Pelsue Model #6759 Work Umbrella.
The instructions contained within this section should be adhered to each and every time the product is used. Any person
tasked with installing or operating this piece of equipment should be familiar with these procedures.
Figure #5.1a:
#6759
Deployed Umbrella
The Umbrella is comprised of a support structure and a sewn assembly. Within the sewn assembly there is a roof, tent
rods, and central support hub with threaded ball-lock. The roof is made of shade material, which is white on the outside,
and black on the inside. This allows the Umbrella to provide ultra violet protection without blacking out all light. Computer
screens which could not be read in direct sunlight are easily visible in the shade of the Umbrella. There is no need for an
additional light source during daylight hours. The shade material also reduces solar heating effects, so the environment
under the Umbrella should be cooler than ambient in sunny locations.
The support structure is based on securing two 4.5” diameter suction cups to a surface near the work area. Then a set
of two hinges and one ball-hub allow the user to adjust the placement and orientation of the Umbrella in three axes, for
full adjustability. The structure has been designed for ease of use, and can be installed and then broken down again in
a matter of minutes.
