P/N UM2101KL_2101KG_REV20181128
8
ASSEMBLY INSTRUCTIONS (CONT.)
5. Pull forward on the side handrails to tip
the scale and gently place it face down
on the floor. Grasp the load cell cable
protruding from the bottom of the
platform and feed it through the
protective metal shield.
6. Plug the load cell cable into the load cell
port located on the back of the platform.
Pull the excess cable through the top of
the center handrail.
7. Thread the four feet into the underside
of the platform. Each foot should be
completely hand tightened then back the
feet out 1-½ full turns. This allows for
proper load cell operation. Carefully tilt
the scale back to an upright position on
the floor.
Warning: Do not drop scale,
as this can permanently damage the
load cells.
Adjust the feet to level the
scale. Be certain that the feet are not
completely tightened into the platform.
8. Obtain the display head and align the
four holes on the back of the display
head with the four mounting holes on
the silver display support. Using the four
included M4 0.7 x 10mm screws (Part
E), fasten the display head onto the
display support using a Phillips head
screwdriver to tighten the screws.
Ensure that the
spacer spring is on
the bolt of the foot
before inserting into
the platform.
