P/N 522BABYHRBracket Mounting Instructions REV20190107_web 3
5.
Flip the support rod over so the side with the
four holes is facing down. Ensure that the end
of the support rod with the most holes
remains on the left side.
6.
Place the BABYHR onto the support rod
aligning the two holes at each end. Ensure
the end of the height rod with the measuring
starting point is on the left side. Obtain the
two flat head screws from the packaging and
insert them through the height rod into the
support rod. Tighten completely using a
Phillips head screwdriver. A magnetic
screwdriver is recommended.
Note:
The packaging includes an extra flat
head screw. Only two screws are needed.
7.
Align the support rod with height rod onto the
mounting bracket on the scale. Ensure that
the starting point of the height rod is flush
with the side of the scale. Obtain the two
thumb screws from the packaging. Insert the
thumb screws through holes A and C on the
support rod and into the mounting bracket.
Completely hand tighten.
8.
Ensure that the stationary paddle of the
height rod is flush with the left side of the
weighing tray. Mounting is now complete.
A
C
