4
INTEgRATINg THE DOOR TO THE
wATER RESISTIVE BARRIER
A.
apply side flashing tape.
Cut two pieces of flashing
tape 4" longer than the frame height of the door. Apply
one piece 1/2" onto the frame cladding, over the nailing
fin and onto the water resistive barrier on each side. The
tape should extend 2" above the top of the door and
2" below the bottom of the door. Press the tape down
firmly while folding down the excess tape at the top and
bottom of the door.
Note: The flashing tape must be applied approximately 1/2" onto
the frame cladding at the jambs and head. Pre-folding the tape
at 1/2" before removing the paper backing will make it easier to
apply the tape correctly. If the siding is less than 1/2" thick, adjust
the dimension of the fold so the exterior sealant line will cover the
exterior edge of the tape.
Exterior
4A
B.
apply top flashing tape.
Cut a piece of flashing tape
long enough to go across the top of the door and extend
at least 1" past the side flashing tape on both sides.
Apply the tape 1/2" onto the frame cladding, over the
top nailing fin as shown. Fold the overlapping tape
down, and press all tape down firmly.
Exterior
1"
4B
C.
Fold down top flap of
water resistive barrier.
D.
apply flashing tape to diagonal cuts.
Cut pieces of flashing tape at least 1" longer than the
diagonal cuts in the water resistive barrier. Apply the tape covering the entire diagonal cut
in the water resistive barrier at both upper corners of the door.
Note: Be sure to overlap the top corners.
Exterior
4C
4D
DOORS
•
ALL
DOORS
•
ALL
DOORS
•
ALL
DOORS
•
ALL
DOORS
•
ALL
DOORS
•
ALL
DOORS
