E.
Plumb and square door. Place shims at each hinge and lock
strike location between the door and the sides of the opening.
)NSERTSHIMSINOTHERLOCATIONSASNEEDEDSTARTINGUPFROMTHE
bottom of the door to square it in the opening. Make sure that the
REVEALAROUNDTHEDOORS ISEQUAL/NDOUBLEDOORSMAKESURETHAT
panels are even across the bottom.
Note: On center latch double doors the lock strike will not be
shimmed since it is located in the center of the unit. DO NOT
over shim.
F.
Check the interior reveal.
Make sure the
measurement from the interior face of the door
to the interior face of the wall is equal at several
points around the door.
Note: If the dimensions are not equal, check
to make sure the fins are folded out to 90° at
all points.
'&ASTENTHEDOORTOOPENINGBYDRIVINGGALVANIZEDROOlNG
NAILSINTOEACHPREPUNCHEDHOLEINTHENAILINGlN
Note: Make sure the fin corner is lying as flat as possible.
When using the optional fin at the sill, attach
the aluminum sill support or wood blocking
under the sill of the door before proceeding
to Step H.
(#AREFULLYOPENTHEDOORS ANDREMOVEALL
shipping spacers.
Note: Be sure to remove the spacers from
the bottom edge of the door panel.
Double doors with center latch:
Designer Series Only:
Use the
construction handle to operate the active door panel. Operate the
flushbolts per the instructions on the label on the strike located on
the astragal.
Architect Series Only:
Use the construction handle to operate both
the active and passive door panels.
I.
Out-swing doors:
Place a dab of sealant in each of the pre-
DRILLEDHOLESINTHEBOTTOMOFTHEDOORFRAMETHENINSERTAX
STAINLESSSTEELSCREWPROVIDED INTOEACHHOLE
Note: Single doors will have two pre-drilled holes, double
doors will have four.
I1.
Out-swing double doors only:
Place a dab of sealant into the
center hole of the strike plate located at the sill of the door.
)NSTALLAXmATHEADSTAINLESSSTEELWOODSCREWPROVIDED
into this hole.
Note: For masonry floors, use a #8 masonry screw instead of
the wood screw.
J.
On center latching (double) doors:
Place shims at the top of the door frame above the center
STRIKEPLATE3ECURETHESHIMSBYINSERTINGAXmATHEADSTAINLESSSTEELSCREWINTOTHEUPPER
door frame through the center hole of the strike plate and the shims into the rough opening.
J1.
On center hinged double doors:
Insert and attach shims directly above the astragal in the center of
the unit.
+ /NEACHHINGESTARTINGATTHETOPINSERTALONGSCREWPROVIDED INTOTHEOPENSCREWHOLE
Make
sure that the screw passes through the shims and into the structural framing.
Note: This step does not apply to center hinge double doors.
&YUFSJPS
Ó
&YUFSJPS
Ó
Ó
*OUFSJPS
Ó
Ó
Ó
£
Ó ä Î ä
{ ä x ä
È ä Ç ä
Ó
Î
-
Ó
*OUFSJPS
Ó
Ó
