3
ASSEMBLE AND ADJUST FEET
PRESS TWO (2) BLACK SNAP FACES TIGHTLY TOGETHER.
REMOVE TAPE LINER ON ONLY ONE SIDE.
ENSURE MOUNTING FOOT SURFACE IS CLEAN
AND DEGREASED. LINE UP TAPE SQUARE TO FOOT.
PRESS THIS ADHESIVE FACE FIRMLY ON ADJUSTABLE FOOT.
LEAVE TAPE LINER ON OTHER SIDE FOR NOW.
TAKE CARE TO NOT TOUCH ADHESIVE SURFACE
WITH HANDS OR OBJECTS.
TEMPORARILY HOLD SADDLE ARM IN
TRUCK BED TO DETERMINE FOOT LENGTH
ADJUSTMENT.
THIS MAY VARY BETWEEN THE TWO SADDLE
ARMS, OR NEED FINE ADJUSTMENT LATER.
INSERT DETENT KNOB WITH LOWER ARM HORIZONTAL
KNOB MUST BE THREADED FULLY IN, TO LOCK ARM HORIZONTALLY FOR SUPPORTING CASE.
REPEAT STEPS 3.1 - 3.4 FOR OTHER MOUNT SUBASSEMBLY.
TO AVOID SCRATCHING PAINT ON LOWER ARM, TAKE CARE TO ALWAYS UNTHREAD KNOB
SUFFICIENTLY TO CLEAR LOWER ARM BEFORE ROTATING.
3.4
DETENT KNOB
(Right Hand Thread)
Foot resting on wall.
Flip over if needed.
Note which slot positions
will be used for bolts.
Place L-bracket on rail in
desired case location.
Hold saddle arm against it
with lower arm horizontal.
Place foot against bed wall.
3.2
3.1
Remove the adhesive liner.
Firmly press adhesive side
to face of mounting foot.
Snap black faces together tightly.
Leave this adhesive liner in
place until later step, for
final adjustments of mount.
FIT M6 BOLTS THROUGH SQUARE HOLES IN SADDLE ARM.
PARTIALLY TIGHTEN M6 LOCKNUTS, FOR FINAL ADJUSTMENT LATER.
Adjust to bed wall
and level the case.
Flip foot over
if required to
fit bed wall.
3.3
3.5
VERTICAL: STOWED
DETENT
HOLES
KNOB
Lower arms have two (2) detent
holes that must be used for
locking in position:
One hole in horizontal position
to support case; one vertical, to
stow case (not-in-use).
3
ASSEMBLE AND ADJUST FEET
3
4