Page 8
www.pelicanwater.com
(877) 842-1635
Complete the Installation
1. Turn on the main water supply.
2. Check for leaks.
3. Plug in the Electronic Head.
Programming the Electronic Head
Note: Power Source - For safety reasons the outlet must be protected by a Ground Fault Circuit
Interrupter (GFCI).
Note: These settings are specific to this system. Do not make changes to the settings unless instructed by
customer service. All settings have to be set by first setting the clock to 12:01 PM. To restart programming,
you must start over at step 1. Do not go to a previous step, you must start over at step 1.
Figure 4
Step 1: Setting the Valve
1. Press and hold the UP or DOWN button to change the clock to 12:01 PM.
2. Press the EXTRA CYCLE button once.
3. Press and hold the UP and DOWN buttons together, until DF is displayed in the left corner. Scroll
using the UP and DOWN arrows until "GAL" is selected. Press EXTRA CYCLE.
4. Follow the steps in the table below to finish setting the valve. When each setting is displayed, use
the UP and DOWN buttons to scroll to the appropriate data setting displayed in the table. Press
EXTRA CYCLE to select the data setting and go to the next setting.
Table 3: Setting the Valve
Step 2: Setting the Time
1. Press and hold down the UP button to change the clock.
2. Press the EXTRA CYCLE button when the time is set. The water valve displayed will stop flashing
when the time is set.
Parameter Display (Left Corner)
Data Display Set To
VT (Valve Type)
Fltr
CT (Control Type)
tc
DO (Day Override)
3
RT (Regeneration Time)
2:00
BW (Backwash)
10
RR (Rapid Rinse)
10
Extra Cycle
Button
Up
Button
Down
Button
Rev B —
Whole House Backwashing Sediment Filter System
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
