Installation Diagram
Installation Steps
(See diagram)
1. Attach the Command Strip to the back of the Wireless Gateway.
2. Insert the included Ethernet cable into the port on the Wireless
Gateway.
3. Insert the other end of the Ethernet cable into a free port on the
back of your Internet router (Note: The Wireless Gateway can
alternately be connected to any Ethernet port at your site which
has Internet access).
4. Insert the power cable from the included power adapter into the
Wireless Gateway.
5. Plug the power adapter into an electrical outlet.
6. Attach the Wireless Gateway to the wall using the Command
Strip you attached to the back of the unit.
Site Setup
Once your newly installed Wireless Gateway is connected and powered
up, you are ready to perform the initial site setup. This is done using the
Pelican “New Site Wizard”.
You will need the Serial Number printed on the side of your Wireless
Gateway to complete the setup.
The New Site Wizard can be found using your browser and going to
www.PelicanWireless.com. Then select the “New Site Setup” tab on the
Pelican home page.
Follow the Instructions on the New Site Wizard page to complete your
setup and begin accessing and programming your thermostats.
Status Indicator Lights
There are 4 indicator lights on the gateway. Two are directly above the
RJ-45 Ethernet connector. They are labeled LINK and ACT. The other
two indicators are labeled LAN and INTERNET.
The indicators have the following meanings:
LAN
Off – No Power
Fast Blink – Power Up (1 second)
Slow Blink – Getting IP Configuration (DHCP)
Solid On – Local Configuration Complete (LAN Active)
INTERNET
Off – Waiting for LAN
Slow Blink – Trying to reach Cloud Servers
Solid On – Internet Active (Connected to Cloud Server)
LINK
– Ethernet Link Status
ACT
– Ethernet Activity Indicator
