Circulation Pump
Installation
1. Install (1) 1" Tee on the incoming water line before the NaturSoft System and (1) 1" Tee on the
outgoing water line after the NaturSoft System. The "Tee" of the fitting should be pointing up
when installed.
2. Install circulation pump using 1" piping (schedule 80 PVC or copper) and 90 degree elbows. Pump
should be installed so the outgoing flow from the pump (side with check valve installed) is flowing
towards the incoming side of the NaturSoft system. (See Notes below.)
3. Plug in pump and push the button on front of pump until LED displays the single "I" indicating the
pump is set to the Low Fixed Speed setting.
Note:
If the piping is not secured to a wall or brace, use pipe straps to support some of the weight of
the circulation pump after installation.
Note:
The pump must be installed in 1 of 2 orientations shown in Figure 3.
Side View
Pelican PRC34 Whole House Filter/Softener Combo
Rev
A
Page 1
3
© 201
7
Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
www.pelicanwaterretail.com
Side View
Incoming
Water
Supply
Outgoing
Water to
House
Circulation Pump
NaturSoft
®
Water Filter
Water Filter
