Peli 9430
User Manual
Mast Operation
1. Lift the LED head fully upwards then slide the mast down to lock into the mount
2. Pull the lever on the black locking clamp, lift the head upwards and snap the lever back into place
3. To collapse the mast, reverse the procedure
Light Operation
1. Press keypad once for full power
2. Press again for low power
3. Press again to switch off
Flash Mode
1. Press and hold keypad for 3 seconds then the LE D head will flash
2. Press keypad again to switch off
Low Battery Warning
Before the battery turns off, the LED head will flash for 3 seconds, every ten minutes to let the user know that the battery voltage is low.
The warning period starts 30 minutes before there is insufficient voltage to power the light.
Battery Charging
Warning
- Do not operate the 9430, RALS with the charger connected.
1. Re move the light head plug from the socket and insert the charger plug into the socket on the light housing and twist the red locking collar
to secure the plug.
2. Connect the charger to the mains AC power supply until the LED on the charger turns green.
NOTE
- the light can be left attached to the charger without any harm to the battery
Charge Cycle Indication
1. Red
= Fast Charge Mode
2. Yellow = 90% Charged
3. Green = Fully Charged Maintenance Mode
Battery Replacement
Contact your dealer for a replacement battery.
To replace, follow the instructions included with the new battery
Environmental
At the end of its technical life, the sealed lead battery should be sent to a suitable recycling center or returned to the point of purchase.
It is advisable to condition batteries every 3 months. Failure to do so will decrease battery life.
Leaving the product unused for long periods of time will decrease battery life.
Withdrawal of the charger from the product prior to a ‘READY’ indication will result in inadequate charge.
Battery Safety Information
WARNING: HANDLE AND StORE BATTERIES PROPERLY TO AVOID INJURY OR DAMAGE BATTERIES
.
CAN BE DANGEROUS!
Most battery issues arise from improper handling of batteries, and particularly from the use of damaged or counterfeit batteries.
Please review the information below to avoid serious injury and/or damage to your property.
Rechargeable Batteries
1. Hazardous location safety approvals for explosive environments are only valid for the Pelican battery pack that is supplied with the light.
2. For replacement battery packs only use the approved Peli battery pack for the model of the light that you are using. The use of
other battery packs will invalidate the safety approval.
3. Lights should only be charged in a non-hazardous location.
4. Lights should only be charged using the Pelican charger base that is supplied with the light.
5. Do not charge with alkaline batteries installed in the light. Attempting this can cause internal gas or heat generation resulting in venting,
explosion or possibly fire.
6. Deep discharge of the rechargeable battery may cause batteries to vent potentially dangerous gasses and electrolytes.
Always dispose of all batteries properly at an approved battery recycling center.
REMOTE AREA LIGHTING SYStEMS
1 YEAR LIMITED GUARANTEE
Peli Products, S.L.U. (“Peli”) guarantees its Remote Area Lighting Systems (RALS) against defects in materials and workmanship under normal
use, service, and maintenance for a period of one year from the date of purchase. With valid dated proof of purchase, Peli will either repair or
replace any defective product, at our sole option. All claims under this guarantee, of any nature, are barred if the product has been altered or in
any way physically changed, or subjected to abuse, misuse, negligence or accident.
For complete details refer to: www.peli.com/peli-warranty
EN
