21
Fasten the appliance to the floor of the
cupboard by screwing two screws through the
holes in the bottom hinge holders (fig. 3b).
Fasten the appliance to the roof of the
cupboard by screwing two screws through the
decorative frame.
fig. 3b
fitting the doors
Open the kitchen cupboard and freezer doors.
First fit the brackets (fig. 4-E) to the freezer
door with the flat side against the door.
fig. 4
Open the kitchen cupboard and freezer doors
as far as possible.
Slide the door guides (fig. 5-F) into the
brackets E with the three screw holes towards
the outside of the freezer door.
fig. 5
Determine the position of the fixing holes for
the door guides F. The door guides should be
fitted at a distance of 25 mm from the edge of
the cupboard door.
Fix the door guides F to the cupboard door.
Screw the door guides in place with the wood
screws and stick the cover plates to the door
guides.
changing the direction in which the freezer
door opens
Using a knife or other sharp object, carefully
remove the cap from the top left of the freezer
door. Then remove the cap from the bottom
left of the freezer door). Close the freezer
door.
INST
ALLA
TION
20
building in
before starting
Decide in which direction the freezer door
should open. If necessary, change the
direction in which the door opens.
The kitchen cupboard must be level and
square in all directions, so that the door of the
appliance will close perfectly.
Draw the plug and the mains flex through the
rear of the kitchen cupboard.
please note:
Wall socket and plug must be accessible at all
times
Fixing materials are in the bottom drawer of
the freezer.
installation
Check the height of the cupboard.
A small gap between the top of the appliance
and the roof of the cupboard is concealed
using the decorative frame. A wider gap is
concealed using the sealing strip supplied.
If necessary, slide the sealing strip B onto the
decorative frame C (see fig. 2).
fig. 2
Place the appliance in the cupboard.
please note:
The front of the decorative frame must be
level with the front of the top panel of the
cupboard.
The vertical gap between the appliance and
the cupboard at the side on which the freezer
door closes is concealed with the plastic
adhesive strip supplied.
Measure the height of the cupboard and cut
the adhesive strip to the correct length.
Pull the appliance forwards slightly out of the
cupboard.
Fasten the strip to the appliance
(see fig. 3a-D).
fig. 3a
Slide the appliance carefully back into the
cupboard with the side on which the door
closes tight against the cupboard wall.
INST
ALLA
TION
B
C
D
E
F
