PELA 81868, Руководство пользователя

Страница: 6 / 10

Contact
PELA Tools
Solängsvägen 13
SE-513 70 Borås
Telefon: 033-202650
E-mail: order@pelatools.com
Environmental protection /
Scrapping
Recycle any unwanted material,
do not throw it in the household
rubbish. All machines, accessories
and packaging must be sorted and left
at a recycling center and disposed
of in an environmentally friendly
manner.
Safety precautions and operating
instructions
When properly used, Hand Held Spot blaster will
deliver many hours of quality spot blasting time.
Hand Held Spot blaster’s unique gravity feed
design is unsurpassed in performance, quality, and
sand flow consistency.
Before operating, read and understand the warning
and operating instructions for the proper use of
your Hand Held Spot Blaster. This is a powerful tool
and every precaution should be used for your own
safety. As well as the safety of others.
WARNING: 1. DO NOT operate Hand Held Spot
Blaster without a face shield and eye protection.
Sand, rust, scale, paint, etc. can rebound from work
being blasted and can cause serious injury.
Including possible blindness.
WARNING: 2. DO NOT operate Hand Held Spot
Blaster without protective gloves. Sand particles
travel at high speed and direct contact with hands
and other skin parts can cause serious abrasion.
WARNING: 3. DO NOT operate Hand Held Spot
Blaster without a respirator mask. Inhaling dust
and other airborne particles into the lungs can
cause a serious health hazard.
WARNING: 4. DO NOT point sand spray at another
person, animal, or your own body parts. Sand
particles can cause serious abrasions. Further,
sand spray can penetrate the average clothing, and
cause injury as well.
WARNING: 5. It is recommended that a rubber
raincoat or similar covering be worn to protect one
from blast media rebounding, and from overspray.
WARNING: 6. DO NOT operate Hand Held Spot
Blaster at air pressures above 125PSI(Pounds per
Square inch).
WARNING: 7. DO NOT fill sand reservoirs while the
compressed air line is still attached to the Hand
Held Spot Blaster. Accidental squeezing of the
trigger can activate sand spray while Hand Held
Spot Blaster is aimed at self or others, causing
serious injury.
WARNING: 8. MAKE SURE ceramic blast nozzle
is fully tightened when in use (hand tighten only).
There is a small steel carburettor insert directly
behind the ceramic nozzle that is held in alignment
by the nozzle. If this insert is not aligned properly.
Sand will not flow.
WARNING: 9. DO NOT use abrasive media larger
than 14 grit. Proper blast media should always be
used in your Spot Blaster. Larger particles will clog
the sand flow control valve and cause faulty or
sporadic operation.
WARNING: 10. DO NOT REUSE SAND unless it has
been strained through a fine screen strainer
(pattern not to exceed 1/16”). Particles larger than
the recommended 14 grit will clog the sand flow
valve.
WARNING: 11. MAKE SURE the sand control valve
is in the off position before connecting the airline
to Hand Held Spot Blaster. Accidentally depres -
sing the trigger with the sand flow valve open, will
immediately initiate the blast mode.