pela tools 86772, Быстрый старт

Страница: 6 / 10

a qualified technician.
20. Workpiece may be sharp. After bending or
cutting workpieces use caution. Be aware of
sharp edges or sharp shreds of metal that may
be created. Use heavy duty gloves when
handling the workpiece.
• NOTE:Performance of this tool may vary
depending on variations in local line voltage.
Extension cord usage may also affect tool
performance.
• WARNING: The warnings, cautions, and
instructions discussed in this instruction
manual cannot cover all possible conditions
and situations that may occur. It must be
understood by the operator that common sense
and caution are factors which cannot be built
into this product, but must be supplied by the
operator.
Features
1. Strong steel construction
2. 12 die sets included to form the most needed
shapes
3. Reliable motor power
4. Very easy to use and changing wheels is done
in seconds
5. Forward and Reverse controlled by foot pedal
6. Multiple micro adjustments for accurate rolling
precision
7. Strong steel Stand provides an ideal working
height
Unpacking
When unpacking, check to make sure that all parts
shown in the Parts Diagram are included. If any
parts are missing or broken, please contact the
seller.
Assembly
The Motor (48#) (Transmission included), Guide
Fence (7#), and Double Directions Foot Pedal(76#)
come preassembled to the Frame (2#). For
additional information regarding the parts listed in
the Parts List, refer to the Parts Diagram.
1. Place the Stand (1#) on the floor. Stand to be
bolted to floor is required.
2. Place the Frame (2#) on the Stand (1#) with 4
Bolts (42#) , Washers (23#), Spring Washers
(12# ) and Nuts (46#).
Roller Dies Vertical Distance Adjustment
The vertical distance between the Roller Dies sets
(13#-22#,49#-61#) should be adjusted before
using,according to the thickness of the workpiece.
Adjust the Pressing Clamp (34#) to achieve an
appropriate distance between the Roller Dies sets.
Roller Dies Horizontal Distance Adjustment
1. Only when you change the roller die sets, you
need to adjust the roller dies horizontal
distances.
2. Remove the Screws (41#) and Fixing Washer
(27#) and then you can change to your desired
die sets.
3. Assemble the Fixing Washer (27#) and Screws
(41#) back and tighten.
4. You can use the Short Bushing (24#) optionally
according to the width of the Roller Dies sets.
5. Loosen the Lock Handles (40#) and adjust the
Driven Shaft (5#),until the horizontal distances
between the Roller Die sets are achieved.
6. Tighten the Lock Handles (40#).
Guide Fence Adjustment
1. Loosen the Guide Fence Clamp (32#) and Slide
the Guide Fence (7#) to your desired position.
2. Tighten the Guide Fence Clamp (32#).
Usage
1. Place the Double Directions Foot Pedal (76#)
on the appropriate location for safe operation.
2. Plug in the machine.
3. Feed the material into the gap between the
Roller Dies sets.
4. You can press the left or the right pedal for
forward and reverse movements.
Maintenance
• Clean the Transmission of dirt and debris after
250 hours of use.
• Lubricate the Copper Bushing inserted in the
Long Sleeve(3#) periodically.
Keep your tool in good condition through regular
maintenance. Before use, check the general
condition of the machine. Check loose screws,
incorrect installation, broken parts and any other
conditions that may affect the machine in
operation. If abnormal noise or vibration occurs,
turn off the tool immediately, examine and correct
the problem before further use. Do not use a
damaged tool until it has been repaired.