6CI
APE03
Pag.
5
Rev. 1-12
(
(
+
INSTALLING THE OUT-OF-ROOM ALARM CONTROL UNIT
1.
Undo the 4 closure screws on the front panel.
2.
Use the three existing holes to fix the box back panel to
the wall: use three screws of a length suitable for the
thickness of the wall to which the panel will be attached. Fit a
rubber washer (supplied) between each screw and the box
backing.
Make all the electrical connections as illustrated in the diagram for the corresponding
model (see relative table in APPENDICES). To effect correct electrical connection
and maintain the protection rating, use appropriate wire/raceway grips to ensure a
good seal. Route the wiring inside the unit in as tidy a fashion as possible: be
especially careful to keep power wires away from signal wires. Use clips to hold wires in place.
3.
Re-close the front panel, making sure that all the wires are inside
the box and that the box seal sits in its seat properly.
Tighten the front panel using the 4 screws, making sure the
O-rings on the head of each screw are used.
CHAPTER 2: INSTALLATION
CHAP. 2 - Installation
2.1
- ENG -
USE AND MAINTENANCE MANUAL