Pegasus W1500 series, Инструкция по эксплуатации

Страница: 31 / 40

28
3
1
4
2
6
5
a: 0.5mm
4 8
9
10
7
Replacing the lower knife
CA
CA
UTION
UTION
Always turn off the power and shut down the air compressor
first, and then well-qualified technicians should replace the knives.
Pay close attention to the knife edges not to injure your
hands and/or finger.
1.
Remove the side cover. Loosen screw
2
. Remove lower
knife
1
. Replace it with the new one.
2.
Move upper knife holder
3
away to the right. Fit lower knife
1
onto the groove on lower knife holder
4
. Check to see if the
cutting edge is flush with the top surface of the needle plate.
Tighten screw
2
.
Adjusting overlap of the knife cutting edges
CA
CA
UTION
UTION
Always turn off the power and shut down the air compressor
first, and then well-qualified technicians should adjust overlap of the
knife cutting edges.
Pay close attention to the knife edges not to injure your
hands and/or finger.
Turn the machine pulley until the upper knife is at the bottom of its
travel. Obtain 0.5mm overlap of the upper and lower knives (see
a
in the illustration). Adjustment is made by loosening screw
6
, mov-
ing upper knife holder
5
up or down. After this adjustment tighten
screw
6
.
Adjusting the lower knife holder left to right
CA
CA
UTION
UTION
Always turn off the power and shut down the air compressor
first, and then well-qualified technicians should adjust the lower
knife holder left to right.
The distance from the right needle to where the fabric is to be cut is
determined by left-to-right position of lower knife holder
4
.
Adjustment is made by loosening screw
7
and turning adjustment
screw
8
as required.
To move lower knife holder
4
to the left, turn adjustment screw
8
clockwise. To move lower knife holder
4
to the right, turn adjust-
ment screw
8
counterclockwise. Loosen screw
9
and move auxil-
iary presser foot
10
to the left or right while moving the lower knife
holder. After this adjustment tighten screws
7
and
9.