Pegasus W1500 series, Инструкция по эксплуатации

Страница: 30 / 40

27
1
3
2
4
5
6
7
9
8
7
9
8
Adjusting the amount of backward tilt
on the presser foot (for W1562-05)
CA
CA
UTION
UTION
Always turn off the power, unplug the machine and then well-
qualified technicians should adjust the amount of backward tilt on
the presser foot.
For W1562-05 Adjust the amount of backward tilt on presser foot
1
according to the elastic lace and fabric to be used. Adjustment is
made by loosening nut
2
and turning screw
3
as required.
● To increase the amount of backward tilt, turn screw
3
clockwise.
●
To decrease the amount of backward tilt, turn screw
3
counter-
clockwise.
FT device (for W1562-05)
Manual lubrication
CA
CA
UTION
UTION
Always turn off the power and unplug the machine when you
apply oil by hand.
When the machine is used for the first time or left unused for some
time, put oil to upper knife crank
4
until the oil wick is fully lubricat-
ed.
Adjusting the fabric guide
Adjust the amount of the fabric to be trimmed.
Adjustment is made by loosening screws
6
and moving fabric guide
5
to the left or right.
Replacing the upper knife
CA
CA
UTION
UTION
Always turn off the power, disconnect the power cord and
then only well-qualified technicians should replace and adjust the
knife.
Pay close attention to the knife edges not to injure your
hands and/or finger.
1.
Turn the machine pulley until upper knife
7
is at the top of its
travel. Remove screw
8
. Then replace the upper knife with
the new one.
2.
To replace the upper knife, press end
a
of the upper knife to
upper knife holder
9
, and then tighten screw
8
.
9
a