Pegasus Power pos lite, Руководство пользователя

Страница: 42 / 43

Chapter 5
Troubleshooting
Please note that the following troubleshooting guide is designed for people with strong
computer hardware knowledge such as System Administrators and Engineers.
Touch Panel Does Not Work
A)
Check CMOS settings, COM3 needs to be “Enabl
B) Check if there are no conflicts between COM3 and any other devices.
C) Check if the ELO driver or the TouchKit driver has been properly installed. Or try to
re-install again (Please refer to the ELO driver installation or the TouchKit driver).
D) Check if the ELO controller or the TouchKit driver on COM3 has been detected during
the ELO driver or the TouchKit driver installation. If yes, then check if the flat cable
from the ELO touch screen or the TOUCHKIT touch screen has been properly
connected to the ELO controller or the TouchKit controller (
Attention: Pin1 mark
should be on the same side as the ELO controller).
E) Check if the ELO controller Green LED is blinking?
If no, there is no DC+5V support for the ELO controller from the motherboard.
F) Touch screen controller could be defective or the touch panel could be defective.
ELO Touch Panel Cannot Calibrate Correctly
A) Please replace the ELO controller, and re-calibrate. If this works, change back to
the original ELO controller, and re-calibrate.
B) If the ELO touch panel still cannot calibrate correctly after changing to a new ELO
controller, the touch panel may be not installed properly or it could be defective.
Cannot Detect HDD
A) SATA cable is not connected properly to main board or it could be defective.
B) HDD power cable is not connected properly to the main board or it could be defective.
C) Check CMOS setup, set SATA HDD to Auto Detect.
D) On-board SATA port could be defective.
16