7
Installing the diverter valve
body
□
From underneath the deck, insert the diverter
valve body (R) with the rubber washer (S),
metal washer (T) and mounting nut (U) through
the hole.
□
From above, thread the flange (Q) onto the
diverter valve body (R).
□
Tighten the mounting nut (U) using a basin
wrench, so that the flange (Q) sits flush against
the finished deck surface.
6
Removing the mounting kits
□
Remove the index (N). Loosen the set screw (O)
with the Hex wrench (Hex: 2.5mm, AA) and
remove the diverter handle (P).
□
Loosen the flange (Q) from the diverter valve
body (R). Adjust the rubber washer (S), metal
washer (T) and mounting nut (U) to the bottom
of diverter valve body (R).
6
Installation (continued)
NOTE:
Make sure that the face marked with "FRONT" on
the diverter valve body (R) is facing forward.
R
S
T
U
Q
N
O
P
AA
Q
R
S
T
U
