ISSUED:09-08-07 SHEET #: 202-9199-1
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
4 of 9
Q
R
ACC 210
For Concrete Ceilings
drill four 5/16" (8 mm)
dia. holes to a minimum depth of 1 3/4" (45
mm). Attach ceiling plate (
R
) using concrete
expansion anchors as shown in 1-1 and 1-2.
Then snap end caps (
Q
) into place.
Align hole in ceiling plate with hole in ceiling.
Gently hammer in concrete anchor.
Use a 10 mm wrench to tighten concrete
anchor to 80 in • lb (9 N.M.) maximum torque
to expand anchors.
FOR PRODUCT SAFETY USE ONLY RAWL
™
#5005 OR HILTI
™
HL814 CONCRETE
ANCHORS.
Order accessory kit
#ACC 210
which contains four .312 x 1.625
(8 mm x 41 mm) concrete expansion
anchors.
• Always attach concrete expansion anchors directly to
load-bearing concrete.
• Never attach concrete expansion anchors to concrete
covered with plaster, drywall, or other finishing material.
WARNING
For Wood Joist Finished Ceiling, Exposed
Wood Joists, or Wood Beam Ceiling.
Drill four
5/32" (4 mm) dia. holes to a minimum depth of 2.5"
(64 mm)
INTO JOIST CENTERS
. Attach ceiling
plate (
R
) with four #14 x 2.5" (6 mm x 65 mm) wood
screws (
P
) using a 3/8" (10 mm) socket wrench.
Tighten wood screws (
P
) so ceiling plate is firmly
attached. Snap end caps (
Q
) into place.
Q
R
P
• Tighten wood screws so that ceiling plate is firmly
attached, but do not overtighten. Overtightening can
damage screws, greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the joists. The use of an "edge to edge" stud
finder is highly recommended.
WARNING
Skip to page 5 for PLCM-UN-1
CONCRETE
PLASTER/
DRYWALL