6 of 30
ISSUED: 02-18-08 SHEET #: 202-9249-6 04-05-11
FOR VESA 75 MOUNTING PATTERN:
Attach adapter brackets (
BB & CC
) to back of display using four M4 x 10mm
screws and four #8 SAE upper washers as shown in fi gure 2.3.
*NOTE:
If hole pattern is in a pocket, attach adapter brackets (
BB & CC
) to back
of display using four M4 x 25mm screws, eight #8 SAE upper and lower washers,
and four retaining spacers as indicated below.
FOR VESA 100 MOUNTING PATTERN:
Attach adapter brackets (
BB & CC
) to back of display using four M4 x 10mm
screws and four #8 SAE upper washers as shown in fi gure 2.3.
*NOTE:
If hole pattern is in a pocket, attach adapter brackets (
BB & CC
) to back
of display using four M4 x 25mm screws, eight #8 SAE upper and lower washers,
and four retaining spacers as indicated below.
FOR VESA 200 MOUNTING PATTERN:
Attach adapter brackets (
BB & CC
) to back of display using four M4 x 10mm
screws and four #8 SAE upper washers as shown in fi gure 2.3.
*NOTE:
If M4 x 10mm screws gets less than three threads of engagement, attach
adapter brackets (
BB & CC
) to back of display using four M4 x 25mm screws,
eight upper and lower #8 SAE washers, and four retaining spacers as indicated
below.
FOR VESA 200 x 200 MOUNTING PATTERN:
Attach adapter brackets (
BB & CC
) to back of display using four M6 x 12mm
screws as shown in fi gure 2.3.
*NOTE:
If M6 x 12mm screw gets less than three threads of engagement, attach
adapter brackets (
BB & CC
) to back of display using four M6 x 20mm screws as
indicated below.
If M6 x 20mm screws get less than three threads of engagement, attach adapter
brackets (
BB & CC
) to back of display using four M6 x 30mm screws as indicated
below.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
display face side down. Place and align adapter brackets (
BB & CC
) on back of display to VESA hole pattern as
shown in fi g. 2.1.
*
NOTE:
If mounting holes are not centered on back of display, center brackets on back of display as shown in fi g.
2.2. Find the VESA
®
hole pattern below, and attach brackets to display accordingly. Verify that all holes are prop-
erly aligned, and then tighten screws using security driver (
FF
).
Installing Adapter Brackets
2
SCREWS
fi g 2.3
UPPER WASHER (
L
)
LOWER WASHER (
L
)
• If screws don't get three complete turns in the display inserts or if screws bottom out and adapter brackets are still
not tightly secured, damage may occur to display or product may fail. Contact customer care for correct hardware to
use.
WARNING
fi g 2.1
BB
CC
RETAINING SPACER
NOTE:
"X" DIMENSIONS SHOULD BE EQUAL.
BB
X
X
CC
fi g 2.2
200 100
75
