6 of 42
ISSUED: 02-15-10 SHEET #: 095-9315-2 04-26-10
Installing Adapter Brackets
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.
Place adapter brackets (
B
) on back of screen, align to holes, and center on back of screen as shown below. Attach
the adapter brackets to the back of the screen using the appropriate combination of screws, washers, and spacers
as shown in steps 2-1 or 2-2.
For cable management option, install cable clip (
P
) in between screen and adapter brackets (
B
).
NOTE:
Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
NOTE:
For
fl at back screens
proceed to step 2-1. For
bump-out or recessed back screen
skip to step 2-2.
B
P
CENTER BRACKETS
VERTICALLY
ON BACK OF SCREEN
X
X
NOTE:
"X" dimensions should be equal.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
2
