7 of 41
ISSUED: 01-25-12 SHEET #: 095-9370-5 02-22-13
For VESA 200 x 200 mounting pattern, skip to step 5 on page 9.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (
B
) on back of display, align to holes, and center on back of display as shown
below. Attach the adapter brackets to the back of the display using the appropriate combination of screws,
multi-washers, and spacers as shown in steps 3-1 or 3-2.
NOTE: Top and bottom mounting holes on display must be used for attaching brackets.
NOTE:
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
NOTE:
For
fl at back displays
proceed to step 3-1. For
bump-out or recessed back display
skip to step 3-2.
NOTE:
"X" dimensions should be equal.
CENTER BRACKETS
VERTICALLY ON BACK
OF DISPLAY
X
X
3
NOTES:
• The number of fasteners used will vary, depending
upon the type of display.
• Multi-washers and spacers may not be used,
depending upon the type of display.
• Use the corresponding hole in the multi-washer that
matches your screw size as shown.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
MULTI-WASHER
Installing Adapter Brackets
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached.
Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
WARNING
B
