9 of 41
ISSUED: 06-05-06 SHEET #: 202-9140-9 06-14-12
Insert two M10 screws (
F
) into swivel box on arm assembly (
C
) as shown. Leave approx. 1/4" of exposed thread.
Hook tilt-roll assembly (
B
) onto M10 screws (
F
).
Insert carriage bolt (
I
) into slot of swivel box as
shown in
fi
gure 6.1. Install nylon washer (
G
) and
tilt adjustment knob (
H
).
Install remaining two M10 screws (
F
) as shown in
fi
gure 6.2. HAND TIGHTEN all four M10 screws
to allow for tilt adjustment. Remove tape from
carriage bolt (
I
). For tilt adjustment, push back
on the top of plasma to relieve pressure on knob.
Adjust tilt to desired position and tighten tilt adjust-
ment knob (
H
), then securely tighten all four M10
screws (
F
) using 6mm allen wrench (
U
).
• Use an assistant or mechanical lifting equipment to safely lift and position the plasma TV.
WARNING
• After tilt is adjusted, all fasteners must be tightened.
Failure to do so will result in damage to the mount.
CAUTION
6
6-1
6-2
SWIVEL BOX
C
fi g. 6.1
fi g. 6.2
SWIVEL BOX
I
B
F
H
G
H
F
I
Adapter bracket not shown for clarity.
Adapter bracket not shown for clarity.
.25"
F