4 of 26
ISSUED: 04-05-11 SHEET #: 090-9201-4 (2013-10-03)
Base assembly can be attached to a mounting surface with a maximum thickness of 3-1/2" (90mm).
Set base (
A
) on mounting surface as shown in fi gure 1.1 and mark the center of the base. Drill a 3/8" (10mm) dia.
hole through mounting surface.
OPTIONAL:
Drill a 3/4" (19mm) dia. hole for cable management.
Remove base cover from base (
A
). Place base on mounting surface and secure using pressure clamp (
B
) as
shown in fi gure 1.2.
Hand tighten pole (
D
) onto base (
A
) as shown in fi gure 1.3. Tigthen set screw to secure pole using 3mm allen
wrench (
L
) as shown in rear view.
CABLE
MANAGEMENT
HOLE
1
Installation of Base
A
A
B
REAR VIEW
fi g 1.1
fi g 1.2
fi g 1.3
SET SCREW
D
