4 of 7
ISSUED: 05-08-08 SHEET #: 202-9280-1
Slide two main tubes (
A
) onto base (
B
) and secure
using four set screws (
Q
) as shown in figure 2 and
detail 1. Tighten screws using 4 mm allen wrench (
S
).
1
2
fig 2
For some situations, bumper strip (
P
) may be
required to keep base (
B
) level. If so, cut bumper
strip (
P
) into five equal pieces and adhere one piece
to each corner and one piece to center of bottom
side of base (
B
).
Note:
The pieces can also be used in other locations
on the base's bottom for other situations.
P
B
4
3
A
B
E
E
G
T
Slide base cover (
E
) down tubes (
A
) onto base (
B
) as
shown below. Secure using two M5 x 8 mm socket
pin screws (
G
). Tighten screws using 4 mm allen
wrench (
S
).
Note: Make sure that notches on bottom of base
cover fit into holes in base.
Slide cable access cover (
F
) into base cover (
E
) as
shown below. Secure using socket pin serrated
washer head screw (
T
). Tighten screws using 4mm
allen wrench (
S
).
A
B
DETAIL 1
Q
