Peco X20 Convertible Trailer Vac, Руководство оператора

Страница: 42 / 46

42
* Mow with sharp blades- A sharp blade cuts cleaner.
damp conditions will require reduced ground speed.
* Mow at higher cutting heights- Remove and mulch no
(Experts recommend not cutting off more than 1/3 of
D. With the mower at high idle speed, engage the mower
deck.
NOTE:
If the collection system does not appear to be
collecting the grass clippings, disengage the deck
A. Perform BEFORE EACH USE the maintenance list
General Safety
B. Start the engine/blower/blade assembly.
C. Start mower.
and PTO assembly, then, engage the parking brake and
turn the mower off. Check upper and lower hoses for any
clogs.
E. Proceed to operate the control levers of the mower.
SECTION III
To obtain the maximum effectiveness from your
collection system, the tips listed below should be
followed:
* Watch your speed- Normal conditions will allow a
OPERATING INSTRUCTIONS
Operation And Tips On Mowing
Only qualified people familiar with this operator’s manual
and the mower’s operator’s manual should operate this
machine.
speed of up to approximately 4 mph, but thick, heavy
referenced in Section IV.
* Wet grass and leaves will decrease effectiveness and
will increase horsepower requirements.
more than 2” of grass length with each mowing.
the grass blade length at any given time.)
* Mow twice, at different height settings, (high, then low),
the mowing conditions such as type and height of turf
Unloading The Collection System
A. Stop the forward movement of the mower.
B. Disengage the mower deck.
* Remember that horsepower requirements will vary with
C. Engage the parking brake.
if grass is extra tall.
terrain is flat or hilly, etc.
NOTE: Collection system blower will have an audible
change in tone when the collection system is full.
grass, moisture content, amount of leaves, whether the
only then, walk back and turn off the collection
H. Once the contents of the container have fallen out,
the container is ready to move back into its normal
operating position. Pull the handle downward and
return the handle into the locked position. Then re-
attach the trailer door and the upper hose.
SECTION IV
D. Once the parking brake has been engaged, then and
system blower.
E. Detach the upper hose from the inlet mount.
F. Remove the trailer door.
G. Unlock and lift the handle to pivot the container
towards the ground. The container will then release
its contents.
NOTE: Do not allow the container to become over-filled
as potential damage may occur to your equipment.
Also, be sure to clean the hood screen as needed.
MAINTENANCE
Maintenance Checklist
1. Check blades and spindles to be sure that no foreign
Before each use:
objects, such as wire or steel strapping bands, are
wrapped around them.
from the spindles before sharpening. DO NOT
2. Inspect blades for wear. Replace if necessary. If it is
hoses. If there are any portions of the hose that have
sharpen blades while still attached to the mower.
condition. Repair or replace any missing or damaged
been torn or worn through, replace immediately.
shields.
After Each Use:
5. Check for wear or deterioration of the upper or lower
1. Clean all debris from machine especially from the
loose parts, damaged bearings, or other damage.
container, and safety decals. Replace any missing or
3. Make sure all shields are in place and in good
illegible decals.
4. Listen for abnormal sounds, which might indicate
necessary to sharpen the blades, remove the blades
Correct any deficiency before continuing operation.
2. Inspect the unit for worn or damaged components.
Repair or replace before the next use. Any
replacement component installed during repair shall
include the component’s current safety decal specified
by the manufacturers to be affixed to the component.