10
To fasten the throttle cable end to the engine, place the
throttle control lever into the “stop” position. Rotate the
engine throttle lever to the “stop” position. Thread the
wire end of the throttle cable into the engine throttle lever
eyelet and tighten the screw. Fasten the throttle cable
sleeve to the clamp on the engine throttle. Rotate the
throttle control lever into the “fast” position to check for
proper installation.
Note:
Cable sleeve may need to be cut depending on
the engine type. Once throttle cable is attached, pull the
box handle to dump the box and be sure the cable does
not alter the movement of the box.
Throttle Base Plate
Throttle Spring
Plate
Throttle
2-13 Throttle Cable Installation
To install the throttle cable kit P#(A0060 for 5.5HP) or
P#(A0294 for 6.0 HP) to the box assembly, align the
large end of the slot in the throttle base plate (Figure 2-
13a) with the rivets located on the front of the box
assembly frame (Figure 2-13b). Place the throttle base
plate over the rivets, Slide the throttle cable kit to the
right, moving the smaller end of the slot over the rivets.
When positioned correctly, the throttle spring plate will
snap into place (Figure 2-13c).
To remove the throttle cable kit, lift the throttle spring
plate and slide the throttle kit to the left.
Figure 2-13a
Figure 2-13b
Box Assembly
Rivet
Figure 2-13c
Box Assembly
Throttle Cable Kit
Properly Positioned
Figure 2-13d
Figure 2-13e
Throttle Cable Clamp
Engine Throttle Lever
Throttle Cable
