Peavey DPE 2P, Руководство по эксплуатации, Страница: 5 / 16

IEC POWER CORD CONNECTION (3)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that you ensure the
DPE
™
2P-4P has the proper AC line voltage supplied. You can find the proper voltage for your DPE2P-4P printed next to the
IEC line (power) cord on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never break off
the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable
grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire
hazard, always be sure that the mixer and all other associated equipment are properly grounded.
COOLING FAN VENTS (4)
The DPE 2P-4P is equipped with an internal cooling fan. In order to avoid damage, DO NOT block the cooling vents!
UPPER REAR PANEL
GROUND LIFT SWITCH (5)
Switches the XLR (8,9) PIN 1 (shield) from direct contact with ground in the event that hum occurs with the input cables
connected. ALWAYS TURN THE GAIN (13) DOWN ALL THE WAY BEFORE OPERATING THIS SWITCH TO AVOID LOUD
POPS OR BUZZES! Turn the gain back up slowly and cautiously to determine if an improvement in the hum or buzz has been
made.
MIC/LINE SWITCH, PRESENT ON BOTH INPUT 1 AND INPUT 2 (6,7)
Switches the sensitivity of the input from line-level to mic-level sensitivity. Pushed in, the sensitivity is set for mic-level input
signals. When the switch is not pushed in, the sensitivity is padded by 30 dB so it is suitable for line-level signals. Note that this
switch changes the input's sensitivity, but does NOT provide phantom power in the MIC position, thus the microphone used
must be dynamic type microphone.
INPUT 1 (8)
Input 1 is switchable between line-level gain and mic-level gain. The line-level input is medium impedance balanced. The jack
(8) on the input 1 panel is a combo female XLR and 1/4" TRS connector. The signal to input 1 is mixed with the signal from
input 2 and fed to the internal crossover and signal processing.
INPUT 2 (9)
Input 2 is switchable between line-level gain and mic-level gain. The line-level input is medium impedance balanced. The jack
(9) is a combo female XLR and 1/4" TRS connector. Input 2 also has a pair of RCA phono jacks (10) wired in parallel with the
above listed inputs. These are mixed in parallel with each other and are Mono inputs (not stereo inputs).The signal to input 2 is
mixed with the signal from input 1 and fed to the internal crossover and signal processing.
6
5
7
8
10
14
9
11 12 16
13
13
15
17
18
20
19
21
22