Peavey DPE 2P, Руководство по эксплуатации, Страница: 4 / 16

ON-OFF SWITCH (1)
This rocker switch supplies AC power to the DPE
™
2P/4P when switched to the ON position. The ON position is with the
left side of the switch pushed "in" or nearly flush with the rear panel.
CIRCUIT BREAKER (2)
The unit is AC power line protected from overloads and fault conditions with a 6 amp circuit breaker (domestic) and
with a 3 amp circuit breaker (export). This breaker should not trip unless there is a fault in the amplifier circuitry or an
abnormal operating condition, which causes excessive mains current to flow. If the breaker trips, set the Power switch (1)
to OFF, and after waiting a brief period of time for the breaker to cool, reset the breaker.
If the circuit breaker trips, the center button will pop outward approximately 1/4", and can be reset by pushing upward and
inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it, the system should
be taken to a qualified Peavey Service Center for repair.
LOWER REAR PANEL
The power amplifiers providing the bi-amplification are low-distortion, switch type amplifiers providing 1200 W peak dynamic
power into the nominal 4 ohm load of the woofer, and a 150 W peak available power into the nominal 8 ohm load of the tweeter. The
woofer amplifier uses IPR2
™
switching technology, and the power supply for both amps is a switch mode type for low weight and high
efficiency. Both amplifiers feature DDT
™
compression, which virtually eliminates audible power amplifier clipping. Cooling is via a
forced-air fan.
Steel handles on each side, DPE-4P has a handle on the top rear to use the built-in rear casters.
The combination of the digital signal-processed dynamic EQ circuitry coupled with the selected woofer and compression tweeter
provides a clarity and impact far beyond conventional powered enclosures. The switching type power amps and switch-mode power
supply, provide this high level of technological sophistication at a light weight and reasonable cost.
APPLICATIONS
The Peavey DPE
™
2P-4P has a variety of applications, including sound reinforcement, public address, side fill system, karaoke and
music playback. A typical signal source for the line-level inputs of the Peavey DPE 2P-4P would be a sound reinforcement mixing
console (mixer) or the output from a CD player, MP3 player or tape deck. A dynamic microphone can be connected directly as well.
4
3
2
1