Pearl Abrasive VX10.2XLPRO, Руководство пользователя

Страница: 7 / 24

– 7 –
vi. BLADE INSTALLATION
1. Carefully raise the cutting head to its highest
position and secure it into place by tightening
the cutting head adjustment knob in the rear
support.
2. Raise the blade guard to the highest position
and tighten the blade guard adjustment knob.
3. Remove the blade shaft nut and outer
flange.
4. Place the blade onto the shaft making sure that
the directional arrows are pointing in the
direction of rotation.
5. After making sure that the blade is firmly
placed against the inner flange, secure it into
place with the outer flange and blade shaft nut.
Make certain the nut if firmly tightened with the
wrench provided, but
do not over tighten!
7. Lower the blade guard and tighten the
adjustment knob.
8. Slightly loosen the rear support adjustment
knob, lower the cutting head so that the blade
is 3/16" to 1/4" below the surface of the cutting
table, and then tighten the adjustment knob
firmly to hold the cutting head in place.
WARNING: Setting the blade too low may
damage the cutting table and if set too high,
the blade may grab the material being cut,
causing damage and possibly injury.
vii. SAFE OPERATING PRACTICES FOR TILE SAW
1. Use safety equipment - wear safety approved
hearing, eye, head and respirator protection.
2. Read and understand the symbol definitions
contained in this manual.
3. Read and understand all warnings and
instructions on the machine.
4. Read all safety materials and instructions that
accompany any blade or accessory used with
this machine.
5. Establish a training program for all operations
of this machine.
6. Always provide a copy of this manual to the
equipment user. If you need extra copies
call our Customer Service Department at
1-800-969-5561.
7. Always select a diamond blade according to
the manufacturers recommendation suitable
for the material to be cut. Never use a blade
having a maximum operating speed lower than
the “No load R.P.M.” marked on the tool
The dust generated by cutting
of tile, marble, stone, bricks etc. can be injurious
to your health. Always operate machinery in well
ventilated areas and provide proper dust removal.
Always wear a dust mask approved for respiratory
protection against these types of dusts and mists.
For your own safety and the
safety of others do not attempt to operate this saw
until you have read and understand the general
safety rules for all power tools and the following
additional safety precaution unique to this saw.
WARNING!
WARNING!
Figure 1