Pearl Abrasive 9566, Руководство владельца/оператора

Страница: 3 / 8

– 3 –
resistance for electrical current to reduce the risk of electric
shock. This machine is equipped with a cord having an
equipment-grounding plug (Fig. 1). The plug must be
plugged into an appropriate outlet that is properly installed
in accordance with all local codes and ordinances. Do not
remove ground pin; if missing, replace plug before use.
PREPARING THE MACHINE FOR
OPERATION
Your floor machine will operate in a wide variety of hard
floors and carpet cleaning applications. Consult with your
local dealer or Pearl Customer Service to select the correct
accessories for the job you are going to perform.
HEXPLATE™, BRUSH, PAD DRIVER
INSTALLATION
Lock the handle in the upright
position and tip the machine back
so it rests on the handle and
wheels. Fit the three slots of the
clutch plate in the back of the brush
or pad driver over the three lugs of
the drive plate. Push it firmly into
position and turn it
counterclockwise until it locks in
place (Fig. 2).
To remove: Tip the machine back so it rests on the handle
and wheels. Turn the brush or pad driver clockwise until it
disengages and lifts off. Do not store the machine with the
brush or pad drivers installed.
PAD INSTALLATION
To install pad, tilt the machine back on wheels until machine
is resting on handle. Center the pad on the pad holder and
insert pad center lock by twisting clockwise. Make sure the
center lock is tight.
To remove: Twist the center lock counterclockwise.
SOLUTION TANK INSTALLATION
Position the tank in front of the
floor machine with the water
release lever of the tank resting
below the floor machine lever.
There should be enough room for
you to pull the tank lever without
accidentally pulling the floor
machine lever (Fig. 3). Attach the
tank to the machine using the two
“V” bolts already included on the
tank. (Fig. 4).
The base of the tank has a
solution hose connected to it on
one end. Insert the other end of
the solution hose in the motor
frame (Fig. 5).
MACHINE OPERATION
1. Install the pad driver and pad, brush or attachment.
2. Plug in machine.
3. Lower the handle to the desired operating position.
4. Place both hands on the handle grips with your fingers
around the on/off lever which extends from one side to
the other underneath the handle grips.
5. The safety “lock-out” lever is
located underneath the right side
handle grip and switch lever. To
unlock the “lock-out” lever, use
your right hand forefinger to press
the lever down toward the back of
the switch box (Fig. 6).
6. While still pressing the lever, pull
the on/off switch lever to start the machine, then
release the “lock-out” lever. The “lock-out” lever will
automatically engage when you release the on/off switch
lever.
TO MANEUVER YOUR FLOOR MACHINE
1. Raise the handle slightly and the machine will go to the
right. The higher you raise it, the faster it will go.
2. Lower the handle and the machine will go left. The more
you lower it, the faster it will go.
3. Practice on a smooth surface until you gain experience
in operating the unit.
TO RE-ADJUST THE HANDLE-LOCK
MECHANISM
Unlock the handle and place it in the
upright position. Tighten the
adjusting nuts until there is a slight
drag when the handle is raised or
lowered (Fig. 7).
CLEAN UP & STORAGE
1. Unplug and wrap it under the cord hook and around
the left side handle grip. Clean the cord and inspect it
for cuts, gashes and loose prongs.
2. Wipe down the machine and store in clean dry place.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 7
Fig. 6