Peaq PBR210HC, Руководство пользователя

Страница: 58 / 126

ENGLISH 57
POWER
No power. Plug the power supply cord into an AC outlet.
Select the correct input source.
Check the connections.
The unit switches to standby mode. This is a power saving feature.
One of the unit’s safety devices is activated.
Press STANDBY/ON on the main unit to turn
the unit on.
OPERATION
The remote control doesn’t work properly. Remove obstacles between remote control
and unit.
Aim remote control at the sensor on the front
panel.
Check batteries and replace them if neces-
sary.
The unit is on but cannot be operated. Confirm the correct drive is selected.
Some operations may be prohibited by the
disc.
Reset the unit as follows:
1. Press STANDBY/ON on the main unit to
switch the unit to standby. If the unit doesn’t
switch to standby, Alternatively, disconnect
the AC power supply cord, wait one minute,
then reconnect it.
2. Press STANDBY/ON on the main unit to
switch it on. If the unit still cannot be oper-
ated, consult the dealer.
Condensation has formed: Wait 1 to 2 hours
for it to evaporate.
Play fails to start even when (PLAY) is
pressed. Play starts but then stops imme-
diately.
Insert the disc correctly with the label facing
up.
Clean or replace disc.
Shut down the unit, wait ten seconds, and re-
start the unit.
Startup is slow. When the unit is turned
on, audio and video output takes a long
time.
Startup takes time in the following situations:
Immediately after a power failure or the AC
power supply cord is connected. When the unit
is connected with an HDMI cable.
Disc tray opens automatically during read-
ing of the disc.
The disc is dirty or any scratch.
The format of the disc is not supported.
Try to reset the unit and press STANDBY/ON,
wait for 5 seconds, and then press this button
again.
Troubleshooting