4. LOG Clear Function
The „Log clear“ function allows you to quickly clear all
logged data points. This function can only be used
when the units is in LOG mode. It can be used when
the user has any number of LOG locations stored.
You should only use the LOG clear function if you
want to clear all the LOG location data that is stored
in unit’s memory. The “LOG clear” function works as
follows:
a. While in LOG mode, press the trigger and then
press the DOWN button until you reach LOG
location ”0”.
Note:
This can only be done when the trigger is
pulled. LOG location “0” cannot be accessed, by
using the UP button.
b.
When LOG location “0” shows in the display,
press the Laser/backlight button. A tone will
sound and the LOG location will automatically
change to “1”, signifying that all data locations
have been cleared.
8.2. Field of View
Make sure that the target is larger than the unit´s spot
size. The smaller the target, the closer you should be to
it. When accuracy is critical, make sure the target is at
least twice as large as the spot size.
-48-
