PeakTech 3335, Руководство по эксплуатации

Страница: 27 / 124

1. Safety Precautions
This product complies with the requirements of the following
European
Community Directives: 2004/108/EC
(Electromagnetic Compatibility) and 2006/95/EC (Low
Voltage) as amended by 2004/22/EC (CE-Marking).
Overvoltage CAT II, Pollution degree 2.
CAT I: For signal level, telecommunication, electronic with
small transient over voltage
CAT II: For local level, appliances, main wall outlets,
portable equipment
To ensure safe operation of the equipment and eliminate the
danger of serious injury due to short-circuits (arcing), the
following safety precautions must be observed.
Damages resulting from failure to observe these safety
precautions are exempt from any legal claims whatever.
* Do not exceed the maximum permissible input ratings
(danger of serious injury and/or destruction of the
equipment).
* The meter is designed to withstand the stated max
voltages. If it is not possible to exclude without that
impulses, transients, disturbance or for other reasons,
these voltages are exceeded a suitable prescale (10:1)
must be used.
* Replace a defective fuse only with a fuse of the original
rating. Never short-circuit fuse or fuse holding.
* Disconnect test leads or probe from the measuring circuit
before switching modes or functions.
* Do not conduct voltage measurements with the test leads
connected to the mA/A- and COM-terminal of the
equipment.
* The 20 A-range is protected. To avoid damage or injury,
use the meter only in circuits limited by fuse or circuit
breaker to 20 A or 4000 VA.
* To avoid electric shock, disconnect power to the unit
under test and discharge all capacitors before taking any
resistance measurements.
-26-