PCAN-Router FD – User Manual
20
2.
Establish a connection between “Boot” and the power
supply (“U
b1
”, “U
b2
”, or “U
b
”) at the connectors of the
PCAN-Router FD.
Connection at D-Sub connector CAN1
between the pins 6 and 9
Connection at the screw terminal
strip between terminals 1 and 7
This measure later applies the “Boot” connection with a
High level.
3.
Connect a CAN bus of the PCAN-Router FD with a CAN
interface connected to the computer. Pay attention to the
proper termination of the CAN cabling (2 x 120
).
Attention!
Risk of short circuit! A CAN cable with D-Sub
connectors must not have a connection on pin 6, as it can be
seen on 1:1 cables, for example. At other CAN nodes (e.g. a
CAN interface of the PCAN series) this line may be applied to
the mass. Damage or destruction of the electronics is a possible
consequence.
Perform the following steps for preparation of the software:
1.
On the supplied DVD, change to the following directory:
/Develop/Microcontroller hardware/PCAN-Router FD/
2.
Copy the subdirectory
PcanFlash
to the local hard disk.
The contained Windows software that copies the Firmware
via CAN (
PcanFlash.exe
) can only be started from a data
carrier that is writable.
Содержание PCAN-Router FD
Страница 4: ...PCAN Router FD User Manual 4 Appendix A CE Certificate 27 Appendix B Dimension Drawings 28 ...
Страница 27: ...PCAN Router FD User Manual 27 Appendix A CE Certificate ...
Страница 28: ...PCAN Router FD User Manual 28 Appendix B Dimension Drawings The figures do not show the original size ...
