PCAN-GPS – User Manual
23
7
Firmware Update
The microcontroller in the PCAN-GPS module is equipped with new
firmware via CAN. The scope of supply includes the Windows
program PCAN-Flash to transfer the firmware from the computer to
the PCAN-GPS module.
7.1
System Requirements
CAN interface of the PCAN series for the computer (e.g. PCAN-
USB)
CAN cabling between the CAN interface and the PCAN-GPS
module with proper termination (120
on each end of the CAN
bus)
Operating system Windows 10, 8.1, 7 (32/64-bit)
If you want to update several PCAN-GPS modules connected to
the same CAN bus, you must assign a unique ID to each
module. See section 3.1
Coding Solder Jumpers
on page 14.
7.2
Preparing Hardware and Software
Perform the following steps for preparation of the hardware:
1.
Switch the off the PCAN-GPS module by disconnecting it
from the power supply.
2.
Establish a connection between “+U
b
” (terminal 1) and
“Boot CAN” (terminal 7) of the module.
