Peachtree amp500, Руководство пользователя

Страница: 6 / 10

1 2
3
4 5 6 7
1
BACK PANEL
B
Power ON/OFF Switch: Connects and disconnects AC INPUT to the unit when
the power cord is connected between the AC INPUT and a 100-240VAC 50/60Hz
AC outlet.
C
AC INPUT & Fuse Holder: For connection to a 100-240VAC 50/60Hz AC outlet
using the included power cord. The fuse can be replaced after turning the
POWER switch OFF and removing the power cord from the AC INPUT. See
the SPECIFICATIONS section for the the specific fuse values required for each
amp500 model. Caution: using an improper fuse value may cause damage to the
unit. Peachtree Audio accepts no responsibility for any damage caused by the use
of improper fuse values.
D
RIGHT & LEFT SPEAKER Outputs: Speaker binding post outputs that accept
banana connectors (insert into hole on back of the post), spade connectors
(loosen, position spade around post, tighten), pin connectors (loosen, insert pin
through hole on post, tighten) or bare wire connections (loosen, loop around post
or insert through hole on the post, tighten).
E
RIGHT & LEFT BALANCED INPUT: XLR style input that accepts a balanced
(differential) audio signal from a preamplifier equipped with a balanced audio
output.
F
RIGHT & LEFT UNBALANCED INPUT: RCA style input that accepts a standard
audio signal from a preamplifier equipped with an unbalanced output.
G
INPUT SELECTOR: Push in for UNBLANCED input and out for BALANCED input.
Note: Do not change the input selection while the unit is powered on.
H
12V TRIGGER INPUT: Enables power on/off control from another product with a
12V trigger output. Insert one 3.5mm cable into this input and connect the other
end to a 12V trigger output of the controlling product. Once connected, both
products should power on and off when using the on/standby button on the front
panel or remote control of the connected product.