Peach A3 - PL115, Руководство по эксплуатации

Страница: 6 / 18

6
Safety notices
This device is intended to laminate doc-
uments inside laminating pouches. It may
only be used for this purpose and observ-
ing these instructions for use. This device
is not intended for use in commercial or
industrial settings.
Carefully read the instructions for use
before use.
Always set the device on a firm surface
near an easily accessible socket.
Do not laminate metal objects.
To prevent electric shock, never use the
device in a moist or wet environment, and
do not allow water to come into contact
with the device, mains lead or the socket.
Do not use the laminator if the mains lead
is damaged!
Never expose the laminator to heat
sources or direct sunlight.
Protect your laminator from moisture, dust,
aggressive liquids, and steam.
Only use the designated speciality film
for laminating.
Description
1
On / Off and film thickness selector switch
2
On / Off indicator light
3
“Ready“ indicator light
4
Film feed slot (front)
5
Film eject slot (rear)
6
Anti-jam switch (ABS)
7
Clamp
Operation
Setting up the device
Switch on the device by setting the
switch
1
to the desired film thickness.
The red On / Off indicator light
2
will light
up. This device has a very short heat up
time and is ready for use after only 40
seconds.
The device is ready for use when the
green indicator light
3
lights up.
Tip: Depending on the film thickness and
the brand being used, you can use the
included clamp
7
to optimise the lami-
nating quality.
Laminating
Attention: Only use laminating pouches
specifically intended for hot laminating.
Please note, the included laminating
pouches are only intended for hot lami-
nating.
Centre the document inside the laminat-
ing pouch to be laminated. Be sure all the
document edges are at least two millime-
tres from the edge of the laminating pouch.
Insert the laminating pouch into the front
film feed slot
4
until the roller grabs and
advances it. Important: the laminating
pouch must be inserted closed end first.
The laminated document will be ejected
through the film eject slot
5
at the back
after approx. 30 seconds (A4).
Remove the laminating pouch from the
device immediately after laminating and
allow to cool down for a minute.
Note: The device will automatically shut
off after approx. 30 minutes.
Troubleshooting
If the laminating pouch accidentally feeds
crooked or gets caught inside the device,
proceed as follows:
Push the anti-jam switch (ABS)
6
to
the left and hold. The laminating pouch
will stop advancing.
Remove the laminating pouch.
Repeat the laminating process.
English